P2610 Lamborghini Auto Trouble Code
Parts or components should not be replaced with reference to only a P2610 Lamborghini DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.
When you fill your car with gas, the vapors in the tank get forced into a canister filled with activated charcoal. Also, on a hot day as the gas heats up and vaporizes, those same vapors push into the canister where they're stored. But the charcoal can only hold so much vapor. At some point it has to be emptied. The emptying process is called canister purge.
P2610 Lamborghini Possible Solution:
Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.
P2610 Lamborghini Description For All Models :
- Lamborghini 350
- Lamborghini 400
- Lamborghini Bravo
- Lamborghini Cala
- Lamborghini Concept
- Lamborghini Countach
- Lamborghini Diablo
- Lamborghini Espada
- Lamborghini Flying Star
- Lamborghini Gallardo
- Lamborghini Gallardo Lp560
- Lamborghini Gallordo
- Lamborghini Islero
- Lamborghini Jalpa
- Lamborghini Jarama
- Lamborghini Lm
- Lamborghini Marco
- Lamborghini Marzal
- Lamborghini Miura
- Lamborghini Murcielago
- Lamborghini Nomad
- Lamborghini P
- Lamborghini P140
- Lamborghini Portofino
- Lamborghini Reventon
- Lamborghini Urraco
|
P2610 Lamborghini Trouble Repair :
If your vehicle failed a P2610 Lamborghini test and the P2610 Lamborghini Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature. |
Code Search
Please fill the search bar to find Auto Trouble Code meaning.